Ensuring your contractor is properly credentialed is a vital step for safety and compliance. To verify a California electrical contractor license, such as #1034067, you should utilize the official resources provided by the state.
It is the responsibility of the homeowner to verify that the hired contractor furnishes the necessary license and insurance required for the work being performed. You can confirm these credentials by following these steps:
- Visit the CSLB Website: Perform a California Contractor License Lookup by visiting the California Contractors State License Board (CSLB) website at www.cslb.ca.gov.
- Search by License Number: Enter the specific license number (e.g., 1034067) to view the contractor’s current status, classification, and standing.
- Check Insurance Coverage: Use the portal to verify that the contractor maintains active workers’ compensation insurance. Additionally, you should independently request proof of general liability insurance from the contractor.
- Review Complaints: The CSLB website will also provide information regarding any pending complaints or past disciplinary actions.
This site is a free service to assist homeowners in connecting with local service contractors. All contractors are independent, and this site does not warrant or guarantee any work performed.
Related FAQs
-
Do I Need to Place Carbon Monoxide Detectors on Every Level of my House?
Read More »: Do I Need to Place Carbon Monoxide Detectors on Every Level of my House?Yes, it is essential to have detection on every floor of your residence. According to the California Electrical Code (Title 24, Part 3), hardwired and interconnected carbon monoxide detectors with battery backup are required on every habitable level of a…
-
Where is the Best Place to Install a Carbon Monoxide Detector in my Home?
Read More »: Where is the Best Place to Install a Carbon Monoxide Detector in my Home?The most effective place to install a carbon monoxide (CO) detector is in the hallway immediately outside of sleeping areas, positioned between 3 and 5 feet from the floor. Because carbon monoxide has a relative density of 0.968—nearly identical to…
-
Is it Illegal for a Handyman to Perform Electrical Panel Work in California?
Read More »: Is it Illegal for a Handyman to Perform Electrical Panel Work in California?Yes, it is illegal for a handyman to perform electrical panel work in California. Under state regulations, handymen are limited to projects where the total cost of labor and materials is under $1,000 and, most importantly, where no building permit…
-
What Electrical Jobs can a California Homeowner Legally do Themselves?
Read More »: What Electrical Jobs can a California Homeowner Legally do Themselves?In California, homeowners may legally perform minor electrical tasks themselves or hire a handyman only if the total project cost (including both labor and materials) is under $1,000 and the work does not require a building permit. However, the majority…
-
What is the Difference between Arc-fault and Ground-fault Circuit Protection?
Read More »: What is the Difference between Arc-fault and Ground-fault Circuit Protection?While both devices are designed to enhance home safety, they address very different hazards. Understanding these differences is essential for meeting the 2026 California Electrical Code standards, especially during kitchen remodels or panel upgrades. Arc-Fault Circuit Interrupters (AFCIs) AFCIs are…